Husqvarna 120iBV Manuel D'utilisation page 10

1. Remove the blower tube if it is installed to the
product.
2. Push the collection bag (A) onto the vacuum outlet
(B). The interlock (C) engages when you hear a
click.
E
D
3. Connect the collection bag strap (D) with the retainer
(E).
4. Connect the shoulder strap (F) with the retainer (G).
5. Make sure that the collection bag is fully closed.
Introduction
WARNING:
safety chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the air inlet for dirt and cracks. Use
a brush and clean off grass and leaves from the
product.
2. Make sure that the product works correctly.
3. Do a check of all nuts and screws and make sure
that they are tight.
10
B
A
C
F
G
Read and understand the
To install the battery charger on the
wall
CAUTION:
screwdriver to install the battery charger to
the wall. An electric screwdriver can cause
damage to the battery charger.
1. Install the battery charger on the wall with the 2
screws (A). Use wall plugs (B) if it is necessary.
A
A
2. Install the 2 screw hole plugs (C).
3. Connect the power cord (D) to the battery charger
and a mains socket.
Operation
Battery
WARNING:
safety chapter before you use the battery.
Read and understand the operator's manual
for the battery and the battery charger.
Keep the battery and the battery charger in the correct
ambient temperatures.
Operation of the battery
Charging of the battery
Do not use an electric
D
Read and understand the
Ambient temperature
5 °C-40 °C / 41 °F-104 °F
5 °C-40 °C / 41 °F-104 °F
2034 - 004 - 20.10.2023
B
C