Candy CSE C9LF-S Mode D'emploi page 62

Proceed as follows to set a delayed start:

- Select a programme.
- Press the DELAY START button (each
time the button is pressed the start will
be delayed by 3, 6 or 9 hours
respectively and the corresponding time
indicator light will light up).
- Press START/PAUSE
commence the delay start operation
(the indicator light associated with the
selected delay start time will blink). At
the end of the required time delay the
programme will start.
It is possible to cancel the DELAY

START by turning
selector to OFF.
Opening of the porthole with delayed
start set, after re-closing the porthole,
press START/PAUSE again to resume
the counting.
TIME CYCLE SELECTION button
To set a timed drying, press this button

until the corresponding indicator light to
the desired duration will light on.
It's possible transform a cycle from

automatic to timed, up to 3 minutes after
the start of the cycle.
After this selection to reset the automatic

drying functioning is necessary to switch
off the dryer.
 In case of incompatibility, all indicator
lights flash quickly for 3 times.
DRYING SELECTION button
This button allows to set the desired

dryness level editable option up to 3
minutes after the starting of the cycle:
Ready to Iron: it leaves the garments
slightly wet to facilitate ironing.
button to
the programme
62
Dry Hanger: to get garment ready to
be hang.
Dry wardrobe: for laundry that can be
directly stored.
Extra-dry: to get completely dry
garments, ideal for full load.
This appliances is equipped with Drying

Manager function. On automatic cycles,
each level of intermediate drying, prior to
the reaching the selected one, is indicated
by flashing the light indicator corresponding
to the degree of drying reached.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
START/PAUSE indicator light
It lights up when the START/PAUSE button
has been pressed.
TIME CYCLE SELECTION
indicator lights
The indicator lights are illuminated to show
the duration selected
button.
DRYING SELECTION indicator
lights
The indicator lights display the degrees
of dryness that can be selected by the
relevant button.
DELAY START TIME / DRYING
STAGE indicator lights
Each time the DELAY START button is

pressed the indicator lights show how
many hours of delay you chosen (3, 6 or
9 hours) and the countdown until the end
of it.
by the relevant