Candy CSE C9LF-S Mode D'emploi page 61

WARNING
Don't touch the buttons while inserting
the plug because
calibrates the systems during the first
seconds: touching the buttons, the
machine couldn't work property. In
this case, remove the plug and repeat
the operation.
PROGRAMME SELECTOR with
OFF position
Rotating the programme selector in both

directions it's possible to select the
desired drying programme.
To cancel the selections or switch off the

appliance rotate the programme selector
on OFF (remember to unplug the
appliance).
START/PAUSE button
Close the porthole BEFORE pressing
the START/PAUSE button.
Press the START/PAUSE button to start

the programme set with the programme
knob (the corresponding indicator light
will light up).
Moreover, if you want to modify the

chosen programme, press the desired
options buttons and then press START/
PAUSE button to start the cycle.
Only the options compatible with the
set programme can be selected.
After switching on the appliance, wait a

few seconds for the programme to start
running.
the machines
61
PROGRAMME DURATION
When a programme is selected the

appliance calculates the time to the end
of the selected programme based upon a
standard loading but, during the cycle, the
appliance corrects
humidity level of the load.
PROGRAMME END
The "END" indicator light will light up at

the end of the programme, it is now
possible to open the door.
At the end of the cycle, turn off the

appliance by turning the programme
selector to the OFF position.
The programme
ALWAYS be put in the OFF position at
the end of the drying cycle before a
new one can be selected.
PAUSING THE MACHINE
Press the START/PAUSE button (the

corresponding indicator light will flash,
showing that the machine is paused).
Press the START/PAUSE button again to

re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
To cancel the programme, turn the

programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
DELAY START button
Appliance start time can be set with this

button, delaying the start by 3, 6 or 9
hours.
the time to the
selector must