Kicker KM604W Manuel D'utilisation page 3

Mounted in the Bow
INSTALLATION
Mounting: Make sure the stainless steel mounting screws and U-type speed clips will not puncture the
fuel cell, wiring, or interfere with any mechanical parts on the underside of the mounting surface. Pre-drill
the mounting screw holes using a 7/64" (2.5mm) bit, and attach the KM coaxial speakers to the boat
by fastening the supplied stainless steel coarse-threaded screws to the boat's structure. If applicable,
use the enclosed stainless steel U-type speed clips. If the supplied hardware is not applicable to your
installation, some other means of securely attaching the speakers to the boat must be used.
Wiring: Carefully place the speaker wire in a location that is clear of standing water and moving
components of the boat. Connect the speaker wire to the speaker terminals.
-
Pro Tip: You are one KXM Amplifi er and a few cables away from a complete, high-quality system with
rock-solid bottom end as only available from KICKER! Please ask your dealer about KICKER KXM amplifi er
upgrades.
2014 KM604W Coax Rev B.indd 3 2014 KM604W Coax Rev B.indd 3
Possible locations for KM
Coaxial Speaker Mounting
Mounted
Mid-Ship
+
Stern
Mounted
3
11/7/2013 3:48:04 PM 11/7/2013 3:48:04 PM