Fermax PLACAS SKYLINE LYNX Manuel D'installation page 34

L L L L L YNX Sk YNX Sk YNX Sk yline
YNX Sk YNX Sk yline yline yline Amplif
L L L L L YNX Sk YNX Sk YNX Sk
YNX Sk yline
YNX Sk
RESTORE DEFAULT VALUES: Reset
The LYNX amplifier has a 'Reset' function which can be used to
restore programmed default values and settings.
This operation is carried out by electrically modifying the equipment,
with the aim of restricting anyone without physical access to the
equipment from modifying it in any way.
Steps:
1. Disconnect the system's power supply.
2. Short the amplifer´s «BS» and «-» terminals.
If the system is equipped with an exit button
press and hold it down.
3. Reconnect the system's power supply and keep the short-
circuit (or maintain the exit button) until you hear a «beep.»
After that sound you can remove the «BS» and «-» terminal´s
short or release the button.
After completing these steps, the panel has restored the settings to
its default values.
Pag 34
yline Amplif Amplif
Amplif Amplif ier
yline yline Amplif Amplif
yline Amplif Amplif ier
yline Amplif
ier ier
ier ier
ier ier
ier
ier
(BS, -)just