Publicité
Les langues disponibles
Les langues disponibles
2. DESCRIPTION OF THE EQUIPMENT
1
10
17
20
6
FIGURE 1:
2
3
4
In weld mode the display is divided into five principal:
Part 1: Machine status
Part 2: Meaning of the active buttons (buttons 2, 3, 4, 5 of fig.1)
Part 3: Size values set
Part 4: Type of process selected
Part 5: Indicates the values that can be set for the various welding
settings (to change the values select using switch 10 and confirm the
selection by pressing the same switch; the value will be highlighted
in a contrasting colour. The values can be changed by turning the
switch, to confirm the new value press the switch again. 10).
Highlighted value: Indicates the parameter that is being changed
using switch 10.
DISPLAYS:
- When the screen comes on, the Fimer logo will appear and the
Fig. 1
Firmware revisions will load.
CONTROL BUTTONS: (2, 3, 4, 5 of fig.1)
Each control button is associated with a specific function shown on
18
19
the display.
9. Switch for adjusting the principal welding settings: This
switch is used to set the principal welding parameters:
MMA/TIG Welding; set the welding current
11. Air grills (must never be obstructed).
12. "-" dinse front connector: negative pole inlet.
Connection socket TIG torch mode.
MMA Mode: Ground clamp
13. Connector for remote control.
14. "+" dinse front connector: positive pole inlet.
MMA Mode:Electrode holder
TIG Mode:Ground clamp
15. Gas Outlet:
MMA Mode: inactive
TIG Mode: Gas connection to the welding torch
FIGURE 2:
17. ON-OFF switch: turns the machine on and off.
18. Input cable: connection cable to the mains power equipped.
19. Gas Outlet:
MMA Mode: inactive
TIG Mode: Gas connection to the welding torch
Fig. 2
20. CONNECTOR OF THE POWER SUPPLY UNIT (OPTION)
Graphic display:
1.
The
3,5''
Part 2
screen
different
Part 3
according
Part 4
welding
Part 5
settings.
colour
displays
screens,
to
the
mode
or
Publicité
