Publicité
Les langues disponibles
Les langues disponibles
English
Important Safety Instructions
WARNING !
basic precautions should always be followed,
including the following:
a ) Read all the instructions before using the
worklight.
b ) To reduce the risk of injury, close supervision
is necessary when a worklight is used near
children.
c ) Turn the worklight off when not in use and
before servicing or cleaning.
d ) Do not operate any worklight after it
malfunctions or is dropped or damaged in any
manner. Return worklight to the nearest authorized
service facility for examination, repair, or electrical or
mechanical adjustment.
e ) To reduce the risk of electrical shock, do not put
worklight in water or other liquid. Do not place
or store worklight where it can fall or be pulled into a
tub or sink.
f ) Only use attachments recommended or sold by
the manufacturer.
g ) This worklight is intended for indoor and
outdoor use.
NOTE: This worklight has a rating of IP55 which means
it has some level of protection from dust and water
ingress. Refer to IEC60529 IP55 for the specific meaning of
this rating. The battery does not have an IP rating on its own.
Do not submerge worklight or battery in liquid.
SAVE THESE INSTRUCTIONS
Specific Safety Rules for Worklights
WARNING: Fire hazard. Do not operate worklight
or charger near flammable liquids or in gaseous or
explosive atmospheres. Internal sparks may ignite
fumes causing personal injury.
•
Do not wash worklight or charger with water or allow
water to get inside light or charger. Do not submerge
worklight in water at any time.
•
Do not expose the worklight to rain or wet conditions.
•
While worklight is in use, do not cover with cloth or
other flammable materials due to increased risk of fire.
•
The worklight is intended for commercial and
household use. It can be used outdoors.
•
Store the worklight indoors when not in use.
WARNING: Do not place the worklight in
a position which may cause anyone to
intentionally or unintentionally stare into the
light. Serious eye injury could result.
CAUTION: When not in use, place worklight on its
back on a stable surface where it will not cause
a tripping or falling hazard. Some tools with large
battery packs will stand upright on the battery pack
but may be easily knocked over.
2
When using the worklight,
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
procedures outlined. When ordering replacement battery
packs, be sure to include the catalog number and voltage.
Your worklight uses a D
WALT charger. Be sure to read all
e
safety instructions before using your charger. Consult the
chart at the end of this manual for compatibility of chargers
and battery packs.
READ ALL INSTRUCTIONS
Important Safety Instructions for All
Battery Packs
WARNING: Read all safety warnings and all
instructions for the battery pack, charger and
worklight. Failure to follow the warnings and
instructions may result in electric shock, fire and/
or serious injury.
Do not charge or use the battery pack in explosive
•
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery
pack from the charger may ignite the dust or fumes.
•
NEVER force the battery pack into the charger. DO
NOT modify the battery pack in any way to fit into
a non-compatible charger as battery pack may
rupture causing serious personal injury. Consult
the chart at the end of this manual for compatibility of
batteries and chargers.
•
Charge the battery packs only in designated
D
WALT chargers.
e
DO NOT splash or immerse in water or other liquids.
•
Do not store or use the tool and battery pack in
•
locations where the temperature may reach or
exceed 104 °F (40 °C) (such as outside sheds or metal
buildings in summer). For best life store battery packs in
a cool, dry location.
or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
...................... safety alert symbol
..................... visible radiation
..................... respiratory
protection
..................... eye protection
..................... hearing protection
IPxx ..................... ingress protection
Publicité
