Makita 9565P Manuel D'instructions page 9

OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Wheel guard (Wheel cover) For depressed center
wheel / flap disc
• Wheel guard (Wheel cover) For abrasive cut-off wheel /
diamond wheel
• Depressed center wheel
• Abrasive cut-off wheel
• Flap disc
• Diamond wheel
• Wire cup brush
• Wire wheel brush
• Abrasive disc
• Inner flange
• Lock nut for depressed center wheel / abrasive cut-off
wheel / flap disc / diamond wheel
• Lock nut for abrasive disc
• Lock nut wrench
• Side grip
• Rubber pad
• Dust cover attachment
NOTE:
• Some items in the list may be included in the tool pack-
age as standard accessories. They may differ from
country to country.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K): 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: surface grinding
Vibration emission (a
Uncertainty (K): 1.5 m/s
Work mode: disc sanding
Vibration emission (a
Uncertainty (K): 1.5 m/s
ENG905-1
): 85 dB (A)
pA
): 96 dB (A)
WA
ENG900-1
2
): 9.5 m/s
h, AG
2
2
): 2.5 m/s or less
h, DS
2
• The declared vibration emission value has been mea-
sured in accordance with the standard test method and
may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
• The declared vibration emission value is used for main
applications of the power tool. However if the power
tool is used for other applications, the vibration emis-
sion value may be different.
WARNING:
• The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
• Be sure to identify safety measures to protect the oper-
ator that are based on an estimation of exposure in the
actual conditions of use (taking account of all parts of
the operating cycle such as the times when the tool is
switched off and when it is running idle in addition to
the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Angle Grinder
Model No./ Type: 9564P, 9565P
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is avail-
able from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
Yasushi Fukaya
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
1.2.2016
Director
ENG902-1
ENH101-18
9