Télécharger Imprimer la page

Samsung RF23J9011SR Mode D'emploi page 15

Masquer les pouces Voir aussi pour RF23J9011SR:

Publicité

Les langues disponibles

Les langues disponibles

If the Refrigerator is on a floor that is not level, it
can cause a height difference between the doors.
• Insert a Flat-Head (-) Screwdriver into the slot
in the Leveling Leg Control Lever and adjust the
level by turning the Control Lever clockwise or
counter-clockwise.
When you rotate the Lever clockwise, you raise
the refrigerator.
When you rotate the Lever counter-clockwise,
you lower the refrigerator.
Flat-blade
screwdriver(-)
• If the Refrigerator is not level back and
front, put a solid panel (such as a plastic
panel, a plastic ruler, etc.) on the floor
where the rear legs will rest, and then fix
it in place with plastic tape.
When you push in the Refrigerator, make
sure the rear legs rest on the panel.
• If you have a wooden floor or similar soft floor,
take care not to damage the floor when pushing
the Refrigerator into place.
DA68-03194D-06.indb 15
Control Lever
English - 15
HOW TO ADJUST THE DOOR
HEIGHT
If any one of the doors is lower
than the other:
• Check if the Refrigerator is
level before adjusting the
door.
• Adjust the door height difference by inserting a
Snap Ring (1) as shown between the door and
the hinge.
You can install a ring on the right side door of
the fresh food compartment and both sides of
the freezer compartment.
• After checking the height difference, select one
Snap Ring with a suitable thickness. Insert that
one Snap Ring only. Inserting two or more Snap
Rings may cause the Snap Rings to slip out or
make a rubbing noise.
• Lift up the lower door and insert the Snap Ring
into the space between the Door and the Hinge.
CAUTION
• To avoid injury, insert or remove Snap Rings
carefully.
• Keep the Snap Rings out of the reach of
children and make sure that children do not
play with them or put them into their mouths.
• 1 mm, 1.5 mm, 2 mm, and 2.5 mm Snap
Rings come with the Refrigerator.
• If the Refrigerator is level before you load it with
food, the Refrigerator may become unbalanced
due to the weight of the food.
If this occurs, adjust the level again using the
same procedure.
• If you raise the door too far, it can rub against
the Top Cover.
(1)
2018. 7. 9.
4:40

Publicité

loading

Ce manuel est également adapté pour:

Rf23j9011sr2