Publicité
Les langues disponibles
Les langues disponibles
1
JACK/FEMALE XLR INPUTS (BAL/UNBAL). The system accept jack or XLR
input connectors. These balanced inputs can be used to connect balanced or
unbalanced microphones or audio sources at line level. The balanced connector is
connected in parallel and can be used to send the audio signal to other amplified
speakers, recorders or supplementary amplifiers.
2
LIMITER LED. The amplifier has a built in limiter circuit to prevent clipping
of the amplifiers or overdriving the transducers. When the soft clipping circuit is
active the LED blinks RED. It is okay if the limit LED blinks occasionally. If the LED
blinks frequently or lights continuously, turn down the signal level.
3
SIGNAL LED. The signal indicator lights green if there is signal present on the
main input.
4
POWER STATUS LED. This green led is ON when the speaker is connected to
the main power supply and the ON/OFF is in ON position.
5
MALE XLR SIGNAL OUTPUT. The output XLR connector provides a loop trough
for speakers daisy chaining.
6
VOLUME CONTROL. Adjust the amplifier volume. This control does not affect
the "Link" - "Input - Link" output level.
7
FLAT/BOOST SWITCH. Set the flat or boost equalization. "Boost" equalization
is a loudness recommended for background music applications, when the system
plays at a low level. For all other applications "Flat" equalisation is recommended.
8
INPUT SENSITIVITY SWITCH. Position the switch in LINE to use a line level
source (0 dB) or MIC to use a microphone source.
9
IEC AC SOCKET. The IEC AC socket connect the power cord to the socket.
(HD 32-A features Powercon input/output main connectors)
10
FUSE CARRIER. Mains fuse housing.
11
POWER MAIN SWITCH. The power switch turns the AC power ON and OFF.
The XLR connectors
use the following AES standard:
PIN 1 = GROUND (SHIELD)
PIN 2 = HOT (+)
PIN 3 = COLD (-)
6
HOT
COLD
REAR
PANEL
1
5
11
GND
CONNECTIONS
BAL. XLR
2
6
3
4
7
1
8
9
10
9
10
11
Publicité
