Napoleon BIPRO 450 Mode D'emploi page 7

Lighting Instructions
Lighting Hole
Igniter
WARNING!
Open lid
WARNING!
Ensure all burner controls are in the off position. Slowly turn on the gas
supply valve.
Main Tube Burner
Lighting
1. Open grill lid
2. Turn left burner
control to high position.
3. Press and hold
igniter button until
burner lights, or light by
match.
4. If ignition is not
immediate, turn burner
control off. Wait 5
minutes.
Repeat.
5. With left tube burner
operating on high, turn
the center and/or right
tube burner to high.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
Do not use rear burner while operating main burner.
WARNING!
If lighting the unit with a match, clip the match into the supplied lighting rod.
Hold the lit match down through the grill and sear plate while turning the corresponding
burner valve to high.
Left Burner Centre Burner Rear Burner
Rear Burner Lighting
(if equipped)
1. Open grill lid
2. Remove warming rack.
3. Turn rear burner
control to high position.
4. Press and hold
igniter button until
burner lights, or light by
match.
5. If ignition is not
immediate, turn burner
control off. Wait 5
minutes.
Repeat.
Right Burner
Off Position
Main Infrared Burner
Lighting
(if equipped)
1. Open grill lid
2. Turn infrared burner
control to high position. control to high position.
3. Press and hold
igniter button until
burner lights, or light by
match.
4. If ignition is not
immediate, turn burner immediate, turn burner
control off. Wait 5
minutes.
Repeat.
7
Side Burner Lighting
(optional)
1. Open burner cover.
2. Turn side burner
3. Press and hold
igniter button until
burner lights, or light
by match.
4. If ignition is not
control off. Wait 5
minutes.
Repeat.
www.napoleongrills.com