Publicité
Les langues disponibles
Les langues disponibles
3. Remove the filter holder by pulling it upwards
and holding it firmly. Do not remove the filter
completely. Lift it only slightly and peel off the
label. Replace the filter in its holder by sliding it
downwards.
4. Remove the label affixed to the bottom of the
filter.
1. Place the appliance on a flat, dry, non-slip surface.
2. Turn the lock knob to the left, to
.
3. Press the lid-opening button.
4. Place your food in the bucket, making sure you
do not exceed the maximum level.
Be sure to follow the advice given in the section
entitled "What types of waste is the appliance
able to process?".
maximum
level
-
When placing food in the bucket without
removing the bucket from the appliance, make
sure that it does not fall into the gap between
the bucket and the body of the appliance. if it
does, remove the bucket and wipe the outside
of the bucket and the inside of the appliance
(bucket housing and the area around the
bucket).
38
5. Replace the filter and its compartment in the
dedicated slot.
actiVation
-
You can also remove the bucket from the
appliance prior to placing food in it. When put-
ting the bucket back into the appliance, align
the triangle on the bucket with the triangle on
the body of the appliance then fit the bucket
into the appliance by rotating it slightly in one
direction and then in the other to ensure that
they are correctly assembled.
Align the triangles on
the bucket and the
body of the appliance
NOTE
The lid will not close if the bucket is not
properly positioned.
5. Before closing the lid, clean any dirt from around
the bucket.
6. Close the lid and turn the lock knob to the right
to
.
NOTE
The appliance will not start if the lock button
is not set to .
7. Plug in the power cord. The appliance will beep
and the lights will flash then switch off.
8. Press
to activate the waste-reduction cycle;
the appliance will beep.
The biowaste reduction cycle consists of 3 steps
that occur automatically one after the other wit-
hout any intervention on your part:
-
Drying
: the waste is heated in order to
dehydrate it.
-
Grinding
: the dried waste is ground to
reduce its volume by about 85%.
-
Cooling
: This natural cooling cycle pre-
vents any risk of burns. The ventilation cycle
is triggered and lasts throughout the cooling
phase.
At each stage, the corresponding light is displayed.
The total cycle lasts between 4 and 8 hours, depen-
ding on the quality and moisture content of the
waste. This is managed by the appliance.
9. When the entire waste reduction cycle is complete,
the appliance will beep and all lights will switch
off.
10. unplug the power cord.
tHe Pause function
You can pause your appliance to add waste when
it is already in operation. however, we recommend
that you do this only during the first half hour of
operation (that is the drying period). After that, the
food may not be properly dried and ground by the
appliance. Moreover, the drying time, and therefore
the total operating time, would be increased.
11. unlock and open the lid.
12. Remove the bucket and dispose of the residue.
For this, please refer to the section entitled "What
should i do with the residue?".
important remarks
- The bucket handle is covered with a sheath. As
the appliance and the area around the bucket
are hot, we advise you to use a potholder to
avoid burning yourself.
- At any time during the reduction cycle, you
can stop the appliance by pressing
for 3
seconds. in this case, you will need to start a
new waste reduction cycle.
- if the appliance has not successfully reduced
some of the waste because it is too big, cut
it into smaller pieces (about 2 to 3 cm), put
it back into the bucket with a new batch of
bio-waste and start a new cycle.
NOTE
Depending on the type of food that is put in
the bucket, the surface coating of the bucket
may be damaged (hard or sharp food). This is
normal wear and tear and has no effect on the
performance of the appliance.
To pause the appliance:
1. Press
; the "Drying in progress" light
flash.
2. Turn the unlock knob to
and press the button
to open the lid.
3. Add the food to the bucket.
4. Close the lid and turn the lock knob to
.
5. Press
to restart the waste reduction cycle. The
"Drying in progress" light
will remain on.
will
39
Publicité
