Power Dynamics CSPS6 Manuel D'instructions page 3

INSTALLATION
1. Drill a hole in the ceiling, big enough to fit the speaker.
2. If the PA system is turned on, turn it off before making any connection.
3. Connect the speaker via two cables to the sound system; when connecting several speakers, make sure that all speakers
have the same polarity and that the amplifier is not overloaded. Before starting with the installation, you must be clear how
many speakers you would like to install.
4. Insert the speaker in the hole.
5. Use the spring clamps to secure the speaker.
Connect the speaker(s) to the amplifier output, using a two-core suitable cable.
If you are connecting multiple speakers, make sure that all speakers have the same polarity and that the amplifier is not
overloaded.
Always make sure that the output signal is not distorted and that your speakers will not get damaged.
When distortions can be heard, either the amplifier or the speaker is overloaded. In order to avoid damage, reduce the volume
immediately when distortions can be heard. When speakers are destroyed by overload, the guarantee becomes void.
Always insulate the unused connection cables.
3