DEFA MultiCharger 1x35A Mode D'emploi page 6

DEFA MultiCharger/MarineCharger/RescueCharger 1x35A and 2x35A are based on modern switch-mode technology and galvanized
divisions. These chargers represent the latest technology within battery charging and will give the batteries optimum life.
It is well suited to battery sizes up to approx. 600Ah and can maintenance charge the battery for an unlimited time. The charger
can stand parallel charging up to 20A parallel consumption at the same time as it charges the batteries. The charging voltage
is temperature compensated with external sensor. DEFA MultiCharger/MarineCharger/RescueCharger 2x35A has two separate
charge outputs and each output has a separate temperature sensor and remote LED.
To satisfy customers with different needs the charger comes without a fixed charging cable. This has to be obtained separately and
there are several different lengths available, as well as remote LED panel. See accessories list below.
Item number
705294
705295
705296
705297
705162
705163
705164
705165
See Picture on page 4. The Picture shows the charge process in a graph with Voltage (V) and Current (I) over time (t)
The LED on the front of the charger shows the charger status:
Green pulse – Charging
Solid green – Fully charged
Red pulse – Error
Read the user manual carefully. Wrong installation can result in damage to the equipment and possible injury. If there are any
uncertainties, please contact DEFA or a qualified person. Fix the charger properly where it is to be installed. See drill guide on page
4. Connect the charger according to the diagram on page 5. The charger is intended for use with lead/acid, AGM and GEL batteries,
but the battery manufacturers recommendations should always be taken into consideration. The charger has to be installed with
the connectors facing downwards to maintain IP rating 44.
Some vehicles have a battery management system. Connect ground according to the vehicle manufacturer's recommendation.
NOTE: To make sure the correct charging voltages the charging cables must not we shortened or made longer
NOTE: Route the cables onto the contacts on the battery charger (Page 3, picture 1) so that they are straight, in order to prevent
the PlugIn contacts from being bent or twisted (Page 3, picture 2).
The charger is maintenance free. All batteries should be inspected monthly as a minimum to achieve the best possible safety. The
charging process is in such way that the batteries remain fully charged without further water consumption than normal evaporation.
6
ABOUT THE CHARGER
AVAILABLE ACCESSORIES
Name
5m Remote LED Panel 1x35
10m Remote LED Panel 1x35
20m Remote LED Panel 1x35
25m Remote LED Panel 1x35
5m Remote LED Panel 2x35
10m Remote LED Panel 2x35
20m Remote LED Panel 2x35
25m Remote LED Panel 2x35
CHARGE PROCESS
INSTALLATION
MAINTENANCE
Item number
705099
705147
705159
705160
704924
704925
Name
2m Charge cable
4m Charge cable
6m Charge cable
8m Charge cable
Bracket 1x35A
Bracket 2x35A