Rowenta DZ5020 Mode D'emploi page 33

quantity only when the iron is at temperature setting •••.
Auto Steam function*
the steam quantity will adjust automatically to the soleplate
temperature.
8 • Shot of steam
(from temperature setting •• upwards)
IMPORTANT Leave an interval of 4 seconds between each
shot and wait until the flow of steam is finished before
standing the iron on its heel.
Press the shot of steam button
steam and remove stubborn creases (fig.14).
9 • Vertical shot of steam
(from temperature setting •• upwards)
TIP Hold the iron 10 to 20 centimetres away from the garment
to avoid burning delicate fabrics.
Hold the iron to the vertical and press the shot of steam button
( fig.15) to remove creases from suits, jackets, skirts, hanging
curtains etc.
IMPORTANT Never direct the steam at persons or animals!
10 • Spray
Press the spray button
11 • Anti-Drip system*
It prevents water escaping from the soleplate when the temperature
is too low.
12 • Automatic electronic 3-position cut-out*
If, although switched on, the appliance is not moved, it will
automatically switch off and the auto off light will blink after the
following intervals (fig. 17):
- After 30 sec., if the iron is left standing on the soleplate or lying
on its side .
- After 8 mins., if the iron is left standing on its heel.
To switch the iron back on, move the iron gently.
* depending on model
Set the steam button to
to generate a powerful jet of
to dampen stubborn creases (fig.16).
29
(fig.13) and