Publicité
Les langues disponibles
Les langues disponibles
BEFORE USE
CONNECTING TO GAS
•
Firstly, make sure that there are residues on the opening key of the gas canister, nor the decom-
pressor, nor the burners nor their components. Check there are no insects or insect nests in any of
the apparatus' openings. An obstructed burner may cause a fire.
•
Clean the burner holes with a special cleaning product for gas burners.
•
Connect the end of the gas hose to the screw thread or the gas hose connector nozzle (optional) by
using a key or a tightening bolt. (not provided). If you replace the hose, repeat the safety instructions
before use.
•
Disconnect the compression valve of the gas canister when the BBQ isn't in use.
•
This apparatus must always be used in a well-ventilated area. It should not be used indoors or in
a garage.
Only use this barbecue outdoors, make sure that there are no leaks. Never check this with a
CHECKING FOR LEAKS
•
Prepare a soapy solution with ¼ washing up liquid and ¾ water.
•
Make sure that all control switches are in the « OFF» position.
•
Connect the compression valve to the gas cylinder, checking all of the connections.
•
Put the soap solution through the hose and the connection points. If bubbles appear, there's a leak
and this must be repaired before use.
•
Check again after fixing the problem.
•
Close the gas valve on the canister once the test is finished.
•
If a leak is detected and it's not repairable, do not try to tap the leak yourself, get in touch with the
aftersales department directly.
PREPARE YOUR BARBECUE FOR FIRST USE
The juices of your food may contain flammable fats, we strongly ad-
vise that you put a layer of sand, roughly 10-15mm in depth in the
inferior fat collecting tray, to facilitate the cleaning process and the ab-
sorption of the fat. This tray must be cleaned after each use.
IGNITING THE PRINCIPAL BURNERS
1. Open the hood and make sure that all the switches are «OFF».
2. Open the gas valve and wait a few seconds.
3. Press and hold the control burner to ignite and turn it anti-clockwise, positioning it to «MAX» to light
the flame. Repeat this various times if necessary.
4. If this ignition process doesn't work, turn the button back to «OFF» and wait a few minutes, then
repeat the previous steps or try to light the gas with a match.
5. Once the initial burner has been lit, repeat stage no. 3 to light the other burners.
6. Adjust the flame to the desired strength, with the aid of the switch.
WARNING: Before cooking the first item, let the bbq heat up for 15 minutes, keep the lid closed and
17/11/2022
flame. Use a soapy solution.
EN
27
Publicité
