Product Use
Installation Concerns
This infant carrier is suitable for vehicle seats with ISOFIX anchor bars. (1)
DO NOT use the rearward facing enhanced child restraint systems in seating
positions where there is an active frontal airbag installed. Death or serious injury
may occur. (2) Please refer to vehicle owner's manual for more information.
DO NOT install this enhanced child restraint on vehicle seats that face sideways
or rearward with respect to the moving direction of the vehicle. (3)
It is recommended to install this enhanced child restraint on the rear vehicle
seat. (4)
DO NOT install this enhanced child restraint on movable vehicle seats during
installation.
Canopy
1
- To assemble the canopy, slide the canopy mounts into the openings in the
seat shell. Check that the canopy is secure by pulling up on the canopy
mount. (5)
2
- Fasten the snaps on the back of the canopy soft goods on both sides. (6)
3
- Unzip the zipper behind the front canopy bow. (7)
4
- Pull the dream drape™ out of the compartment and attach the
dream drape™ to the magnets on each corner at the front of the infant
carrier. (8)(9)
5
- The canopy window can be opened for ventilation. (10)
Handle Adjustment
1
- The infant carrier handle can be adjusted to 3 positions. (11)
2
- To adjust the handle, squeeze handle buttons on both sides. (12)-1
3
- Rotate handle until it clicks and locks into any of the 3 positions. (12)-2
Be sure handle is locked in the carry position before lifting the infant carrier.
An unlocked handle could move unexpectedly, causing injury to child.
Handle has to stay upright when used in the car.
8
PIPA urbn instructions
Head Support Height Adjustment
Shoulder harness straps must be nearest to your childs shoulders (13).
If the shoulder harness straps are not at proper height, the child might be
ejected from the enhanced child restraint if there is a crash.
Head support must be installed at all time while using the infant carrier. (14)
Pull the head support up or down to adjust the position. (15)
Securing Child
Use Infant Insert
We recommend using the infant
insert while the baby is under 60
cm or until they outgrow the infant
insert. The infant insert increases
the protection for children.
After the child is placed into the seat, check whether the shoulder harness
straps are at proper height.
1
- Press the harness adjustment button while pulling the shoulder harness to
the desired length. (16)
2
- Unlock the buckle of the harnesses by pressing the red button. (17)
3
- Place the child into the infant carrier and lock the buckle. (19) Engage the
buckle. Please refer to (18).
4
- Pull down the adjustment webbing and adjust it to the proper length to
make sure your child is properly secured. (20)
Make sure the the shoulder harness straps are snugly tightened. Any belt
slack reduces the safety performance of the child restraint system.
Installation using ISOFIX system
1
- Attach the ISOFIX guides to the vehicle's ISOFIX anchor bars. (21) The
ISOFIX guides can protect the surface of the vehicle seat from being torn.
They can also guide the ISOFIX connectors.
Remove the infant insert when
the infant's shoulders no longer fit
comfortably.
9
PIPA urbn instructions