Bose BASS MODULE 500 Mode D'emploi page 4

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Bose Corporation could void the user's
authority to operate this equipment.
This device complies with FCC and ISED Canada radiation exposure limits set forth for
general population. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
This device complies with part 15 of the FCC Rules and with ISED Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment should be installed and operated with a minimum distance of 20 cm between
radiator and your body.
This device for operation in the band 5150 – 5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems.
Receiver Category = 2
Product Power State Table
The product, in accordance with the Ecodesign Requirements for Energy Related Products
Directive 2009/125/EC and the Ecodesign for Energy-Related Products and Energy Information
(Amendment) (EU Exit) Regulations 2020, is in compliance with the following norm(s) or
document(s): Regulation (EC) No. 1275/2008, as amended by Regulation (EU) No. 801/2013.
Required Power State Information
Power consumption in specified power
mode, at 230V/50Hz input
Time after which equipment is
automatically switched into mode
Power consumption in networked standby
if all wired network ports are connected
and all wireless network ports are activated,
at 230V/50Hz input
Network port deactivation/activation
procedures. Deactivating all networks will
enable standby mode.
REGU L ATORY AND L EGA L I NFO RM ATIO N
Per Annex II 3(a) of Regulation 801/2013 ("Lot 26"
amendment of 1275/2008), the requirement to deactivate
a wireless port "does not apply to products which rely on a
single wireless network connection for intended use and
have no wired network connection."
Power Modes
Standby
< 0.5 W
< 2.5 hours
N/A
|
4 E N G
Networked Standby
Bose wireless < 2.0 W
≤ 20 minutes
< 2.0 W