Blue Sky Outdoor Living OKC1322PTS Manuel Du Propriétaire page 8

of each of the four large mounting holes, two in the front and two in the back
on the support base. Make sure the support base does not move while you
are marking the holes and that the holes are marked in the center.
With a Center punch and hammer, tap a starter punch in the center of each
of the 4 pencil marks that you marked to align with the four large mounting
holes of the support base.
With a drill and provided 7mm drill bit place the drill bit tip into the punched
guide you made to keep the drill bit on center. Drill through the cabinet base.
Repeat on the remaining hole locations marked and punched.
8 | www.bluesk youtdoorliving.com