Publicité
Les langues disponibles
Les langues disponibles
FAULTS
Faults table
When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Symptom
The refrigerator emits a slight
odour when used for the first
time.
The appliance does nothing;
the lighting is not lit.
Temperature inside
refrigerator too high or too
low.
Water runs from the
refrigerator.
Appliance makes a noise.
The LED lighting does not
work.
Possible cause
New appliance.
Plug not in socket.
Thermostat off.
Thermostat setting incorrect.
The door seals are dirty or the
seals are damaged.
Door seals not installed
correctly.
Defrost water drain clogged.
Incorrect positioning of food
in the refrigerator (or freezer).
There is an object against the
appliance.
LED lamp faulty.
The device has just been
switched on and it takes
about 1 minute for the lighting
to come on.
Solution
This is normal and disappears
when the appliance starts
cooling.
Insert the plug in the socket.
Adjust the thermostat to the
correct setting.
Adjust the thermostat
properly.
Clean the door seals. Call
the service centre if the door
seals are damaged.
When changing the direction
of rotation of the door, the
door seal must be turned
180°. Check if this is correct.
Clean defrost water drain (see
"Defrost").
Place foods in the proper
manner in the refrigerator or
freezer.
Remove the object.
Consult a service technician
about LED lighting that is not
working. For safety reasons,
you are not allowed to repair
LED lighting yourself.
This product contains a light
source of energy efficiency
class F.
EN 25
Publicité
