Publicité
Les langues disponibles
Les langues disponibles
How much detergent
to use
•
The amount of detergent to use depends on the soil level of
•
Water hardness can change over a period of time. Find out
your dishes, hardness of your water, and the type of
your water's hardness by asking your Sears Sales Associate,
detergent. If you use too little, dishes will not be clean. If you
local water department, water softener company, or county
use too much in soft water, glassware will etch.
extension agent.
Detergent Dispenser fill recommendations
per dish load soil level and water hardness
Light Soil or Prerinsed
Normal - Heavy Soil
Water Hardness
Main Wash section
Pre-Wash section
Main Wash section
Pre-Wash section
Soft
4 tsp (20 mL)
Empty
6 tsp (30 mL)
2 tsp (10 mL)
(0-2 grains per
Fill to Soft Water line
Fill above the Soft Water line
Fill to Soft Water line
U.S. gallon}
Medium
6 tsp (30 mL)
2 tsp (10 mL)
6 tsp (30 mL)
4 tsp (20 mL)
(2-6 grains per
Fill above the Soft Water line
Fill to Soft Water line
Fill above the Soft Water line
Fill to Hard Water line
U.S. gallon}
Hard
8 tsp (40 mL)
4 tsp (20 mL)
9 tsp (45 mL)
7 tsp (35 mL)
(7 grains per U.S. gallon
Fill to Hard Water line
Fill to Hard Water line
Fill cup completely
Fill cup completely
and above)
NOTE:
Fill amounts
shown
are for standard
powdered
detergent.
Amounts
may vary if you use liquid
or concentrated
powdered
detergent.
Tablet
detergents
should
be placed
in the main wash
section
of the detergent
dispenser
with the cover
closed.
Follow
instructions
on the package
when
using liquid
dishwasher
detergent,
concentrated
powdered
detergent
or tablet
detergent.
IMPORTANT:
Your dishwasher
is designed to use a liquid rinse aid. The use of rinse aids greatly improves drying by allowing water to
drain from the dishes after the final rinse. They also prevent water from forming droplets that can dry as spots or streaks. Do not use a
solid or bar-type rinse aid.
4. Clean up any spilled rinse aid with a damp cloth.
Filling the dispenser
The rinse aid dispenser holds 5 oz (150 mL) of rinse aid. Under
normal conditions,
this will last for about 1 to 3 months.
1. Make sure the dishwasher
door is fully open.
2. Turn the dispenser knob to "Open" and lift it out.
A
.........
3=
A. Dispenser knob
B. Indicator
C. Indicator window
Pour rinse aid into the opening until the indicator points to
"Full." Take care not to overfill. (When the rinse aid indicator
drops to the "Add" level, add more rinse aid.)
Full
Add
5. Place the knob back into the opening and turn to the "Lock"
position.
Rinse aid setting
The amount of rinse aid released into the final rinse can be
adjusted. For most water conditions, the factory setting of 2 will
give good results. If you have hard water or notice rings or
calcium spots on your glasses or dishes, try a higher setting.
Lock
Open
To adjust the setting
1. Remove the dispenser knob.
2. Turn the arrow adjuster inside the dispenser to the desired
setting by either using your fingers or inserting a flat-blade
screwdriver into the center of the arrow and turning.
3. Replace the dispenser knob.
10
Publicité
