Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
C
C2
D1
D
C
GB 14
• Hook the cooker hood (D) onto the motor unit (C) using the two
screws (D1). Let the two screws (D1) slide into the slots (C2) on the
motor unit (C). Observe the minimum height of the cooker hood in
relation to the hob.
• Flip the cooker hood (D) forwards and screw it to the motor unit (C)
using the two screws (D2) and the screws (D1).
• Remove the grease filters and attach the cooker hood (D) to the
motor unit (C) using the three connectors. Attention! One of the
connectors is located in a terminal box. Remove the cover (snap
off) and make the connection in the terminal box.
D2
• Secure the wires (using a cable tie) so that they are not resting on
D
the grease filters.
• Tighten the screws (B1) of the upper telescopic duct and then allow
the lower telescopic duct (A) to fall onto the cooker hood (D).
• Check that the cooker hood is working correctly.
A
D
C
B
A
D
Publicité
