Publicité
Les langues disponibles
Les langues disponibles
{
2.
Move the door strike
Using a Torx®! T25 screwdriver, remove the 2 screws securing
the
door strike to the door frame of the dryer. Rotate the
strike 180° and attach to the opposite side of dryer door
frame, as shown.
f—
3.
Remove inner door from outer door
f—
4.
Remove outer window assembly
from trim ring
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
16
Using a Phillips screwdriver, remove the 2 screws from the
outer window retainer and rotate the outer window assembly
clockwise until the square notches line up with the 4 tabs
on the trim ring indicated with arrows in the figure A above.
Then lift out the outer window and retainer up and off the trim
ring and set aside (B).
Publicité
