Publicité
Les langues disponibles
Les langues disponibles
CONNECT VENT
LEVEL DRYER
(-
&
a "
1. Connect vent to exhaust outlet
» Level dryer
Ze
|/
2
AZ
AZ
ha S
'Ay
Place
level here
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
Check levelness of dryer from
in dryer. If connecting to existing vent, make sure vent is
side to side. Repeat from front to back.
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
NOTE: The dryer must be level for the moisture sensing system
with a 4" (102 mm) clamp.
to operate correctly
|
( 2
« Move dryer to final location
ax
Not Level
LEVEL
Not Level
(—
2. Adjust leveling legs
Move dryer to final location, taking care not to crush or
kink vent or flexible gas line.
After dryer is in place, remove corner posts and cardboard
from under dryer.
if dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the floor and the dryer does not rock.
14
Publicité
