Publicité
Les langues disponibles
Les langues disponibles
By pressing the info button
The white dotted line indicates the gradient at which the process is set. Pressing info again
displays additional information from the process.
• Unless the thermostat function is switched on, heating will stop automatically when the
set temperature is reached. A loud beep sounds, and the display shows information about
how the heating process went. The beep can be ended by pressing "STOP".
• When the thermostat function is switched on, unless you press "STOP", the workpiece will
be kept at the set temperature for the time set. Heating starts again after the temperature
has dropped to the temperature set in the system settings to which the workpiece is
allowed to drop. Each time the set temperature is reached, the induction heater sounds a
loud beep.
• During this cycle, a clock is displayed at the bottom of the screen with the time remaining
for the temperature hold mode. After the temperature hold time has elapsed, the heater
sounds a continued loud beep, which can be ended by pressing "STOP".
• Each time the induction heater stops, it automatically demagnetises the workpiece.
• The heating process or thermostat feature can be interrupted by pressing the "STOP" button.
9.6 Workpiece handling
• After pressing "STOP", place the sensor(s) on the side of the pole.
• By pressing "STOP", the workpiece is demagnetised automatically.
• Wear heat-resistant gloves. Place the crossbar with the workpiece on a clean surface or if
the heater is equipped with a swivel arm, swivel the crossbar forwards into the positioning
cam, slide the workpiece off.
• Fit the workpiece without delay and prevent cooling down.
© Bessey Tools
, the heating process is displayed graphically.
EN
FR
33
Publicité
