Publicité
Les langues disponibles
Les langues disponibles
By pressing the info button
again displays additional information from the process.
• Heating runs until the set temperature is reached or until the set time has elapsed,
whichever comes first. The workpiece is then demagnetised automatically and a loud,
continuous beep sounds. Press "STOP" to switch off the beep.
9�5 Heating in temperature & speed mode
• Position the workpiece and any sensors (according to chapters 7 & 8.)
• Switch on the heater and select the temperature & speed mode if necessary.
• If necessary, change the temperature and gradient set by pressing the current values.
• Press "START". The heating starts, you will hear a slight humming sound.
• The display shows the current temperature of the workpiece.
• If a second sensor is attached to the workpiece, this temperature also appears on the display.
32
, the heating process is displayed graphically. Pressing info
© Bessey Tools
Publicité
