Publicité
Les langues disponibles
Les langues disponibles
8�1 Heating a hanging workpiece
• Place the induction crossbar with the bearing on the poles. Make sure that the bare metal
side is positioned straight on the poles.
• Always choose an induction crossbar that fills the bore of the bearing as much as possible.
You can even use 2 crossbars at the same time. This promotes optimal, fast and even
heating.
• Make sure that the bare-metal sides are sufficiently coated with acid-free grease to ensure
optimal contact and avoid vibration.
• Swivel arm models: swivel the crossbar open (towards you) until it clicks in the safety
positioning cam. Slide the workpiece over the crossbar until it is in the middle. Swivel the
crossbar back to the pole.
• Always make sure that the workpiece does not come into contact with the plastic casing
of the heater. When the heating is finished, follow the instructions in reverse order. Use
heat-resisant gloves to move the heated workpiece.
© Bessey Tools
EN
FR
23
Publicité
