Publicité
Les langues disponibles
Les langues disponibles
Only when sensors are connected, the heating process is displayed graphically by pressing
the info button
. Pressing info again displays additional information from the process.
• During heating, the pre-set time counts down to 00:00. When 00:00 is reached, the
induction heater switches off. The workpiece is then demagnetised automatically and a
loud, continuous beep sounds. Press "STOP" to switch off the beep.
9�4 Heating in temperature or time mode
• Position the workpiece and sensor (according to chapters 7 & 8.)
• Switch on the heater and select the temperature or time mode if necessary.
• If necessary, change the temperature and/or time set by pressing the current values.
• Press "START". The heating starts, you will hear a slight humming sound.
• The display shows the temperature and the time left until process completion.
© Bessey Tools
EN
FR
31
Publicité
