Proline PLC234WDSL Manuel D'utilisation page 21

 Once defrosted, food should be consumed quickly.
MAKING ICE CUBES
Fill the ice cube tray (not supplied) with ¾ full of drinking water and place in the freezer compartment.
If the ice cube tray is stuck to the compartment, loosen with a blunt tool only.
To loosen the ice cubes, twist the ice cube tray slightly or hold briefly under flowing water.
DEFROSTING
Refrigerator compartment defrosts fully automatically
While the refrigerating unit is running, beads of condensation or hoarfrost from at the back of the refrigerator compartment.
This is normal. It is not necessary to wipe off the condensation or frost. The rear panel defrosts automatically. The condensation
runs into the condensation channel and is conveyed to the refrigerating unit where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so that the condensation can run out.
Defrosting the freezer compartment
The freezer compartment does not defrost automatically, otherwise the frozen food would start thawing.
A layer of frost in the freezer compartment impairs refrigeration of the frozen food and increases power consumption. Remove the layer of hoarfrost
regularly.
Do not scrape off hoarfrost or ice with a knife or pointed object. Doing this may damage the refrigerant tubes.
1. Remove the frozen food and place temporarily in a cool location.
2. Set the temperature control knob to the 0 position and disconnect the mains plug from the mains socket.
3. To accelerate the defrosting process, place a pan of hot water on a stand in the freezer compartment.
4. Wipe up condensation with a cloth or sponge.
5. Wipe dry the freezer compartment.
6. Plug in the appliance and adjust the temperature control knob as desired.
7. Put the frozen food back in the freezer compartment.
DOOR CONVERSION
If you need to hinge your fridge and freezer doors on the opposite side it is recommended that you call your local authorised service agent to make this
conversion or ask a technician. The below drawings are only for reference.
Before you reverse the doors, you should ensure the appliance is unplugged and empty. It is recommended to use a crosshead screwdriver and a spanner
(both not supplied).
1.Remove the screw (1) that fixes the upper hinge cover (2) and remove the upper hinge cover.
Remove the screws that hold the upper hinge and remove the upper hinge.
Remove the upper hinge hole cover (4). Lift the door and place it on a padded surface to prevent it from being scratched.
2. Remove the middle hinge. Lift the freezer door out of the
bottom hinge and set it aside.
3. Unscrew the axis from the lower hinge and reverse the lower hinge. Screw the
axis on the lower hinge again. Remove the adjustable foot and fit it to the
opposite side. Fit the lower hinge to the opposite side.
EN-6