Publicité
Les langues disponibles
Les langues disponibles
Surfaces are different, and damage caused by using the wrong
cleaning agent can be avoided by observing the information in
the table below.
Do not use
sharp or abrasive cleaning agents.
■
The surface could be damaged. If such a substance comes
into contact with the front of the appliance, wash it off
immediately with water.
metal or glass scrapers to clean the glass in the appliance
■
door.
metal or glass scrapers for cleaning the seal.
■
hard scouring pads or cleaning sponges.
■
Wash new sponge cloths thoroughly before use.
cleaning agents with high concentrations of alcohol.
■
Cleaning agents
Caution!
Before cleaning, unplug the appliance from the mains or switch
off the circuit breaker in the fuse box. Clean the outside of the
appliance and the cooking compartment with a damp cloth and
mild detergent. Dry with a clean cloth.
Area
Cleaning agents
Appliance front
Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
metal or glass scrapers for cleaning.
Recess in cooking
Damp cloth:
compartment
Ensure that no water seeps through the
turntable drive into the appliance inte-
rior.
Malfunction table
Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Troubleshooting
Error message
The appliance does not work
Three zeros light up in the display.
The appliance is not in operation. A
cooking time appears in the display.
The microwave does not work.
Possible cause
The plug is not plugged in.
Power failure
Faulty circuit breaker
Faulty operation
Power failure
The rotary selector was actuated acciden-
tally.
The Start button was not pressed after set-
ting.
The door was not fully closed.
The Start button was not pressed.
Area
Cleaning agents
Turntable and turnta-
Hot soapy water:
ble ring
When putting the turntable back in
place, make sure it slots in correctly.
Door panels
Glass cleaner:
Clean with a dish cloth. Do not use a
glass scraper.
Seal
Hot soapy water:
Clean with a dish cloth, do not scour. Do
not use a metal or glass scraper for
cleaning.
Appliance front with
Hot soapy water:
stainless steel
Clean with a dish cloth and dry with a
soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such residues. Special stainless
steel cleaning agents can be obtained
from the after-sales service or from spe-
cialist shops. Do not use glass cleaners
or metal or glass scrapers for cleaning.
Cooking compart-
Hot soapy water or a vinegar solution:
ment made of stain-
Clean with a dish cloth and dry with a
less steel
soft cloth.
If the oven is very dirty: use oven
cleaner, but only when cooking com-
partment is cold. It is best to use a stain-
less-steel sponge. Do not use oven
spray or other aggressive oven cleaners
or abrasive materials. Scouring pads,
rough sponges and pan cleaners are
also unsuitable. These items scratch the
surface. Allow the interior surfaces to
dry thoroughly.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
You can take remedial action yourself for some error
messages.
Remedy/note
Plug the plug in
Check whether the kitchen light works.
Look in the fuse box to make sure that the cir-
cuit breaker for the appliance is in working
order.
Switch off the circuit breaker in the fuse box.
Switch it back on after approx. 10 seconds.
Reset the time.
Press the Stop button.
Press the Start button or cancel the setting
with the Stop button.
Check whether food residue or debris is
trapped in the door.
Press the Start button.
21
Publicité
