Clatronic BS 1304 Mode D'emploi page 32

4. Set the "carpet/hard floor" switch, depending on the floor
covering.
5. Vacuum at a steady speed. There is no need to exert pres-
sure.
NOTE:
Pay attention to the range that can be covered with the
cable length!
Air Slide (2)
Open the air slide on the hose handle in order to regulate the
airflow or to clear any particles sticking to the nozzle.
Switching off and Winding up the Mains Lead
1. Turn the vacuum cleaner off by the on/off switch and
remove the plug from the socket.
2. Keep the plug in your hand.
3. Press the cable winding button and guide the cable. Hold
the cable to avoid wrapping.
Maintenance
Emptying the dust collector
Empty the dust collector once the collected dirt reaches the
MAX marking.
1. Disconnect the mains plug from the wall socket.
2. Disconnect the hose from the hose connection.
3. Press the button (8) to
release the dust collector.
Remove the dust collector.
(Fig. A)
4. Empty the dust collector
over a dustbin. In order to
do so, press the button on
the dust collector to open
the base plate.
(Fig. B)
5. Then close the base plate again.
6. Attach the dust collector to the appliance. First position it
at the bottom of the appliance and then secure it with the
hook on top.
7. Check that the position of the dust collector is secure by
briefly lifting the appliance at its carrying handle.
32
BS 1304_IM
Filter
Your appliance features 4 filters. The common dust bag system
has been replaced by a transparent dust collector. The higher
flow speed of the collector allows for heavy dirt and smallest
floating particles to be separated from the "sucked-in air".
It is thus not necessary to buy dust bags.
HEPA filter
Clean the filter element twice a year.
CAUTION:
• Never wash the filter in the washing machine.
• Do not use a hairdryer for drying.
• Only use the appliance after the filters have been
installed correctly.
Proceed as follows to remove, clean and reinstall the filter ele-
ment:
1. Empty the dust collector as described previously.
2. Remove the dust collector lid. To do so, turn the
marking on the lid towards the
element from the dust collector.
3. Remove the filter element from the lid by turning the filter
element towards .
4. Pull the nylon filter from the HEPA.
5. Use a brush to clean the filters. In case of heavy staining,
clean the filters under running water.
6. Let the filters air-dry completely before refitting them!
7. Wipe the dust collector with a damp cloth and then wipe it
dry.
8. Once the filters are completely dry, attach the nylon filter to
the HEPA filter (see the figure on page 3).
9. Reinsert the filter element into the lid of the dust collector,
using the notches in the lid. Turn the filter element towards
the symbol until it clicks into place.
10. Reinsert the lid including the filter element into the dust
collector. Close the lid until the
the symbol.
11. Fit the dust collector in the appliance.
Outlet filter
The appliance is also equipped with an outlet filter.
It is located on the rear of the device under the parking aid.
1. Push down the lever (12) and remove the ventilation grille.
2. Remove the filter insert and clean it as described above.
3. Place the completely dry filter back into the ventilation grille.
4. Put the ventilation grille back on the appliance. Observe the
guide lugs. The ventilation grid must engage audibly.
symbol. Pull the filter
marking is aligned with
17.11.2015