Overview; Putting Into Operation - Venta LPH60 WiFi App Control Mode D'emploi

OVERVIEW

Display
1
2 On/off switch
Evaporator compartment
3
4 Water tank
Disc stack
5
6 Water basin
Fragrance/filter compartment
7

PUTTING INTO OPERATION

01 10
Attention! Make sure that the appliance is switched off and the
power plug is disconnected.
Unpack the appliance and set it up. Open the fragrance/filter compartment
01
7, remove the pre-filter 9, remove and open the VENTAcel filter 10.
02 Re-insert the VENTAcel filter 10 and pre-filter 9.
03 Inserting the fragrance: Twist open the fragrance cap and insert it into the
fragrance holder 8. Insert up to three fragrances into the fragrance holder 8.
Close the fragrance/filter compartment 7.
04
Open the evaporator compartment 3 and remove the water tank 4.
05
Open the water tank 4 and fill up to the MAX marker with cold water.
06
Close the water tank 4 securely.
07
Insert the water tank 4 into the water basin 6 and close the evaporator
08
compartment 3.
09 The display 1 can be adjusted to three positions.
10 The power cable can be adjusted to the desired length by winding it up in
the cable compartment 11.
Move the appliance with the transportation wheels 14 to the desired place.
Lift the appliance slightly on the right sight.
Attention! The coupling of the mains cable must be
plugged firmly into the device!
Please remove the protective foil for battery and
remote control.
Fragrance holder
8
9 Pre-filter
10 Filter
11 Cable compartment
12 Hygiene Disc (pre-assembled)
13 Remote control
14 Transportation wheels
Venta LPH60 WiFi
ON/OFF
Set fan stage
EN 16
App Control