SilverCrest 719770 Mode D'emploi page 7

WARNING: DO NOT over-tighten. You should use a calibrated torque wrench to torque the nut
to the correct value after using the impact wrench.
WARNING: NEVER increase the air pressure above the maximum operating pressure stated in
the 'Specification' if the tool stalls while tightening or the torque produced is insufficient.
WARNING: Be aware that air tools may hold residual pressure after use. Always bleed air
pressure from the tool after shutting off air supply.
Accessories
• Accessories for this tool, including sockets and socket sets, are available from your Silverline
stockist. Spare parts can be obtained from your Silverline dealer or www.toolsparesonline.com
Maintenance
WARNING: Always disconnect from the air supply and depressurise before cleaning or carrying
out any maintenance.
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose over time
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth
IMPORTANT: There is very little that can go wrong with your air tool and it should be noted that
when an air tool fails to work it is generally because the internal workings have corroded due to
dirty, wet air and failure to follow the instructions given below.
Daily maintenance procedure:
If an inline lubricator is not fitted to the air supply, the tool must be manually lubricated:
1. Disconnect from the air supply
2. Pour 3-4 drops of oil into the air intake
3. Operate the machine at low speed to thoroughly lubricate all internal workings
• If the machine is in constant use or used for long periods at a time, repeat the above procedure
up to 3 times per day
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL
• Failure to comply with the operating and maintenance instructions may invalidate the guarantee
Weekly maintenance procedure
1. Disconnect tool from the air supply
2. Remove the hex screw to open the Oil Point (6) marked 'OIL' and pour in a few drops of air tool
oil
3. Replace the hex screw and tighten to seal the oil point
4. Connect tool to the air supply and run motor for several seconds at low speed to distribute the oil
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: www.silverlinetools.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
Holtum-Noordweg 11
Unit 4
6121 RE Born
The Netherlands
Disposal
• As with other power tools, air tools should not be disposed of with household waste
• Air tools may contain traces of tool oil and other lubricants and so must be recycled accordingly
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
Air Impact Wrench
7