Hilti NURON C 4-22 Mode D'emploi Original page 21

6.1 Replacing the supply cord
DANGER
Risk of injury! Risk of electric shock.
▶ The product may be serviced and repaired only by authorized, trained personnel! This personnel must
be specially informed of any possible hazards.
If it is damaged, the supply cord has to be replaced.
Comply with the country-specific regulations for electrical safety.
1. Unplug the charger's supply cord from the power outlet.
2. Pull the rubberized foot out of the cover and remove the securing screw exposed by removal of the
rubberized foot.
Materials
Torx screwdriver T10
®
3. Flip the cover open.
4. Take a photo or draw a sketch so that you will be able to recall the routing and conductor-to-terminal
assignment of the supply cord.
5. Carefully depress one of the terminal clips with a flat screwdriver to release the conductor. Disengage
the conductor from the terminal clip. Repeat this step for the second conductor and then remove the
faulty power cord.
6. Install the new supply cord. Depress one terminal clip with a flat screwdriver and insert the end of the
conductor into the terminal clip. Release the terminal clip and check that the conductor is secure in the
terminal clip. Repeat this step for the second conductor.
Materials
Supply cord
2289588 (EU, 220­240V)
2289589 (US, 110­120V)
2289910 (GB, 220­240V)
2300624 (GB, 100­120V)
2289911 (KR, 220­240V)
2289912 (RU, 220­240V)
2289913 (BR, 220­240V)
2289914 (JP, 100­120V)
2289915 (AUS 220­240V)
2289917 (ARG, 220­240V)
Select the supply cord of a type suitable for use with this charger from this table or contact Hilti
Service.
7. Seat the supply cord in the cable guide exactly as the original cable was routed prior to replacement.
Use the photo taken beforehand or the sketch you drew as reference.
8. Flip the cover closed and re-install the securing screw.
9. Push the rubberized foot back into the cover.
10. Plug the supply cord into a power outlet and check that the charger is in full working order.
▶ LED shows: Charger is in full working order.
▶ LED does not light up: Charger is not in full working order.
▶ Contact Hilti Service.
7 Transport and storage
Transport
▶ Make sure that the equipment is held securely throughout all transport operations.
*2292547*
2
2292547 English 17