HammerSmith HydroBlast PRO Mode D'emploi page 13

TROUBLESHOOTING
Description
Weak lithium-ion battery or
no power.
The battery is not charging
No or low water flow
Water leakage between the
tip of the device and the
barrel
M36209_Hammersmith_HydroBlast PRO_Manual_20240221_SR.indd 13 M36209_Hammersmith_HydroBlast PRO_Manual_20240221_SR.indd 13
Possible cause
Low battery power
The battery is not connected to
the charger.
There is an accumulation of
air in the suction and pump
system
Air has accumulated inside the
flexible hose system.
The filter is clogged. The hose
is kinked.
The water is contaminated
with impurities.
Clogged nozzle or barrel
Loose connection of hose,
hose adapter and water inlet.
The nanofilter is not
completely submerged in the
water
The barrel is not installed
correctly.
13
Solution
Remove the battery from the device
and charge it for 4 hours.
Re-insert the battery into the charger
to ensure the connection is secure.
Bleed the system: Remove the hose
adapter from the main unit. Turn the
device upside down. Fill the pistol with
a cup of water through the water inlet,
and turn it on at the same time. Once
the water has flowed into the system,
reattach the hose adapter.
To release the air accumulated in the
hose, immerse the filter in the bucket
of water and stir vigorously while
turning on the device. If water begins
to flow, you can continue using it.
Clean the filter of any debris that may
have obstructed the flow. Unfold and
straighten the hose.
Replace it with clean water
Remove any debris and make sure the
barrel is connected properly.
Securely reconnect the hose adapter
to the device's water inlet.
Submerge the nanofilter in the bottom
of the water bucket. Make sure that the
bucket is filled with clean water.
Remove the barrel and inspect it
for blockages, contamination and
damage. If it is clogged, clean it. Re-
attach it and make sure it is installed
correctly.
21.02.24 16:41 21.02.24 16:41