HammerSmith HydroBlast PRO Mode D'emploi page 12

out of the device. As soon as you release the button,
the device switches off.
2. with a garden hose (#13a+b): Your garden hose
requires a standard quick-coupler (not included in
delivery contents). Connect one end of the garden
hose directly to the main unit and the other to the
tap. Then turn on the tap. As soon as the tap is
opened, water comes out of the device. This is not
a defect, the device does not have a water start-
stop regulator. You can purchase a commercially
available regulator valve (not included in delivery
contents) for the garden hose or high-pressure
hose. Attach the regulator valve directly to the
device and connect your garden hose or high-
pressure hose to the this (#13b). Hold the main
device firmly and press the on/off button on the
handle. Keep the button pressed while using. As
soon as you release the button, the device switches
off. If necessary, turn off the water supply at the
regulating valve.
SPRAY NOZZLE SETTINGS (#14+15)
To control the spray jet, simply turn the nozzle
clockwise or anti-clockwise. When you turn the
nozzle anti-clockwise the jet becomes wider,
and when you turn it clockwise the jet becomes
more concentrated. You can adjust the jet during
operation.
ATTACHING & FILLING THE SOAP FOAM
BOTTLE (#16-18)
1. Twist off the top cap of the soap foam bottle in
an anti-clockwise direction to open the bottle.
Fill the bottle to the top with the desired soap or
shampoo.
2. Then put the top cap back on, and turn it
clockwise to seal the bottle.
3. Remove the long-range nozzle from the high-
pressure cleaning gun.
4. To attach the filled soap foam bottle to the gun,
insert the tip of the soap foam bottle cap into the
opening on the device (bottle facing left), press
firmly into the device, and turn the bottle to the
right until it locks. Note: Only hand-tighten.
5. To remove the soap foam bottle, gently press
inward toward the gun and twist the bottle to the
left to loosen and remove.
M36209_Hammersmith_HydroBlast PRO_Manual_20240221_SR.indd 12 M36209_Hammersmith_HydroBlast PRO_Manual_20240221_SR.indd 12
USING (#19)
Please follow the installation instructions to
assemble the high-pressure cleaner and get it ready
for use. After assembly, ensure that the flexible hose
with the nanofilter is submerged in water and that
the barrel and accessories are correctly assembled
and secured.
• To operate: Point the device at the floor and
press the on/off button on the handle to start
the pressure washer. The device must first be
primed to remove any pockets of trapped air in
the pump system. To remove any air build-up,
simply press the trigger while moving the hose
with the filter in the bucket of water at the same
time. It may take approximately 20 seconds for
water to be emitted from the cleaner. Once you
have a continuous flow of water, you are good to
go. Release the trigger to stop.
• To prevent an automatic switch-on of the device,
press the safety switch to the right. To unlock,
press the safety switch to the left.
12
21.02.24 16:41 21.02.24 16:41