Candy RP4 H7A2TRE-S Mode D'emploi page 67

PAUSING THE MACHINE
Keep the START/PAUSE button pressed

for about 2 seconds (the name of the
programme and the residual time display
will flash, showing that the machine is
paused).
Press the START/PAUSE button again to

re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
To cancel the programme, turn the

programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
DELAY START button
This button allows to delay the start of the

programme from 30 minutes (1 hour on
some models) to 24 hours in 30 minutes
intervals (1 hour on some models).The
delay selected is shown on the display.
After pressing the START/PAUSE button

the time showed decrease minute after
minute.
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
TIME CYCLE SELECTION button
 It's possible transform a cycle from
automatic to programmed, up to 3
minutes after the start of the cycle.
 The progressive pressure increases the
time in 10 minute intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
In case of incompatibility, all indicator

lights flash quickly for 3 times.
MEMO button
This button allows you to store the options
set on a cycle.
MEMORY:
select the programme and the desired
options, then press the button MEMO for 3
seconds (before starting the cycle). The
writing MEMO (all the digit on some
models) will blink for 2 seconds and the
options connected to the cycle selected will
be set.
RECALL:
after the selection of the cycle press the
button MEMO for recall the stored options
(not the cycle).
The delay start function can't be
memorized.
DRYING SELECTION button
This button allows to set the desired

dryness level editable option up to 3
minutes after the starting of the cycle:
Ready to Iron: it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger: to get garment ready to
be hang.
Dry wardrobe: for laundry that can be
directly stored.
Extra-dry: to get completely dry
garments, ideal for full load.
This appliances is equipped with Drying

Manager function. On automatic cycles,
each level of intermediate drying, prior to
the reaching
indicated by flashing the light indicator
corresponding to the degree of drying
reached.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
67
the selected one, is