Panasonic N-SE792S Mode D'emploi page 24

IP4929_3BD63CP_00_140417:IP3854_38N04CP_01_111101 2014-4-17 10:57 Page 22
This feature allows you to program the
oven as a kitchen timer. It can also be
used to program a standing time after
cooking is completed and/or to program a
Delay Start.
To Use as a Kitchen Timer:
Example: To count down 5 minutes.
1.
2.
3.
To Set Stand Time:
Example: To cook at P6 power for 3
minutes, with stand time of
5 minutes.
1.
Press 5 times
2.
3.
4.
5.
Timer Feature
• Press Timer/Clock.
• Set time, using Time
Dial, to 5 minutes.
• Press Start.
Time will count
down without oven
operating.
• Enter the desired
Power Level (see
page 15 for directions).
• Set cooking time,
using Time Dial, to 3
minutes.
• Press Timer/Clock.
• Set stand time, using
Time Dial, to 5 min-
utes.
• Press Start.
Cooking will start.
After cooking, stand
time will count down
without oven
operating.
CAUTION:
If oven lamp is lit while using the timer
feature, the oven is incorrectly pro-
gramed. Stop oven immediately and
re-read instructions.
To Set Delay Start:
Example: To delay the start of cooking
for 5 minutes, and cook at P6
power for 3 minutes.
1.
2.
3.
Press 5 times
4.
5.
NOTE:
1. When each stage finishes, a two-beep
signal sounds. At the end of the pro-
gram, the oven will beep five times.
2. If the oven door is opened during
Stand Time, Kitchen Timer or Delay
Start, the time on the display will con-
tinue to count down.
3. Stand time and Delay Start cannot be
programmed before any automatic
Function. This is to prevent the starting
temperature of food from rising before
defrosting or cooking begins. A change
in starting temperature could cause
inaccurate results.
4. The maximum programmable time of
Standing Time, Kitchen Time or Delay
Time is up to 90 minutes.
22
• Press Timer/Clock.
• Set delay time, using
Time Dial, to 5 min-
utes.
• Enter the desired
Power Level (see
page 15 for directions).
• Set cooking time,
using Time Dial, to 3
minutes.
• Press Start.
Delay time will
count down. Then
cooking will start.