Getting Started; Finishing - Electrix RC Circuit 1 Manuel D'utilisation

getting started

1. Extend Antenna and Power on Transmitter
3. Do a Test of Transmitter's control of vehicle
with vehicle wheels off ground
Note: Seat motor brushes by driving smoothly on a flat surface during use of the first battery charge.

finishing

1. Power off Electronic Speed Control (ESC)
3. Disconnect Battery
InstructIon Manual
2. Connect battery (page 3) to Electronic Speed Con-
trol (ESC) and power on the ESC
4. Start driving slowly and if the vehicle does not
go straight, adjust steering trim dial on Transmitter
2. Power off the Transmitter and Lower Antenna
Note: To prevent
damage to antenna,
collapse the antenna
by pulling the lower
sections in first.
4. Remove Battery from vehicle
en
6