Transmitter Controls - Electrix RC Circuit 1 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

transmitter controls

reverse sWItch
Allows you to change the
direction of steering (ST. REV)
and throttle (TH. REV) controls.
(Default settings are "N")
st. d/r
Adjusts the amount the front wheels
move when turned left or right
(Steering Dual Rate)
PoWer sWItch
Power on
or off the
transmitter
Battery level IndIcator
Good battery power
Low battery power
Note: Red light will flash with an
audible signal (beep) when batteries
are low
Note: The center pin on the charge jack is positive
InstructIon Manual
antenna
Pull antenna out to its
full length for best results
(ECX1067 Antenna Only)
charger Port
Read instructions before charging.
Charge only rechargeable batter-
ies. Non-rechargeable batteries
may burst causing injury to persons
and/or damage to property.
aM 27 Mhz transMItter crystal
AM Transmitter Crystal
Part #
Description
ECX1081 Crystal Set 1 26.995
ECX1082 Crystal Set 2 27.045
ECX1083 Crystal Set 3 27.095
ECX1084 Crystal Set 4 27.145
ECX1085 Crystal Set 5 27.195
ECX1086 Crystal Set 6 27.255
throttle trIgger
Forward (when
TH. REV switch
on N)
.
Controls power to motor for forward
or reverse (See TH. REV switch)
AM Receiver Crystal
(RX)
(RX)
Note: Paired AM crystals must be
replaced to change control frequencies.
Do NOT use FM Crystals.
steerIng trIM
Adjust top make the vehicle
drive straight with no input
at the steering wheel
throttle trIM
Adjusts the neutral point of
the electronic speed control
steerIng Wheel
Control steering. Right and
Left steering with ST. REV
Switch on N (See ST. REV
switch)
Reverse
(when TH.
REV switch
Stop
on N)
en
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Circuit 10

Table des Matières