en
wheel assembly
front Wheel
electrical layout
Note: For correct operation, Channels 1
and 2 must be used as shown in wiring
diagram.
The motor can be disconnected from the
ESC at the connectors in the wiring.
fasteners
No.
Description
TAPPING BINDER HEAD M3x10mm
TAPPING BINDER HEAD M3x12mm
TAPPING BINDER HEAD M3x16mm
TAPPING BINDER HEAD M3x18mm
TAPPING FLAT HEAD M3x10mm
TAPPING FLAT HEAD M3x12mm
TAPPING FLAT HEAD M3x15mm
TAPPING FLAT HEAD M2x16mm
11
detaIl of drIve hex
Note: When installing wheel, make sure drive hex is aligned with the drive
pin. When the drive hex is removed, the drive pin can fall out of the axle.
ECX1071
DYN1050
No.
Description
BINDER HEAD M3x8mm
BINDER HEAD M3x12mm
BINDER HEAD M3x20mm
BINDER HEAD M3x25mm
BUTTON HEAD M3x30mm
BUTTON HEAD M2x6mm
TAPPING BUTTON HEAD M3x10mm
rear Wheel
ECX1070
Channel 2
Channel 1
ECX1068
ECX1069
No.
Description
BUTTON HEX M2.5x4mm
BUTTON HEX M2.5x8mm
STEP SCREW M3x0.5x7.4mm
STEP SCREW M3x0.5x13.4mm
STEP SCREW M3x0.5x10.5mm
SET SCREW M3x3mm
SET SCREW M3x12mm
1/10 electrIc stadIuM truck
AM Receiver
Crystal (RX)
No.
Description
SET SHAFT SCREW M3x13mm
WASHER 5x7x0.5mm
WASHER 3x8x0.5mm
WASHER 2x7x0.5mm
FLANGED LOCK NUT M4
LOCK NUT M3
E-CLIP E2.5