If the power tool has been overloaded, release the pressure applied and then allow it to run under no load for approx.
60 seconds.
2.10 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section. The
power tool may otherwise loose performance and the extension cord may overheat. Check the extension cord for
damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross
1.5 mm²
section
Mains voltage 100V
Mains voltage 110-
20 m
120 V
Mains voltage 220-
50 m
240 V
Do not use extension cords with 1.25 mm² or 16 AWG conductor cross sections.
2.11 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.12 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled: The unit
must provide a power output in watts of at least twice the value printed on the type identification plate on the power
tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and
starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.
2.13 DG-EX 125/5" dust removal hood for grinding 2
The tool is suitable only for occasional use with diamond cup wheels for grinding mineral materials.
CAUTION
Use of this guard for working on metal is not permissible.
NOTE
It is recommended that a dust removal system consisting of matched components, i.e. dust removal hood and a
suitable Hilti vacuum cleaner, are used for grinding mineral materials, such as concrete or stone. These serve to
protect the operator and increase the life of the power tool and disc used.
2.14 DC‑EX 125/5"‑M dust removal hood with guide carriage for cutting and slitting 3
Cutting and slitting work on mineral materials may be carried out only when the power tool is equipped with a dust
removal hood with guide carriage.
CAUTION
Use of this guard for working on metal is not permissible.
NOTE
It is recommended that a dust removal system consisting of matched components, i.e. dust removal hood and a
suitable Hilti vacuum cleaner, are used for cutting and slitting mineral materials, such as concrete or stone. These
serve to protect the operator and increase the life of the power tool and disc used.
2.15 DC‑EX 125/5"‑C compact dust removal hood for cutting 4
For cutting masonry and concrete.
2 mm²
2.5 mm²
30 m
30 m
40 m
100 m
3.5 mm²
14 AWG
50 m
50 m
75 ft
en
12 AWG
125 ft
21