Master TAKE CONTROL BASIC UR81 Guide Utilisateur page 9

4. Programming
To make your remote suitable for your own equipment, you
have to program it once. You can do this by entering a code,
related to the brand and type of equipment you want to
control. You can program any equipment under any MODE
key. For example, if you have three videorecorders, you can
program videorecorder 1 under VCR, videorecorder 2 under
AUX and videorecorder 3 under CD.
4.1. Manual code entry
Take your code book and search for the list matching the
equipment you are looking for, e.g. TV or VCR. Next, find
the relevant brand (e.g. Sony). Now you will find one or more
3-digit codes. If there is more than one code, it depends on
your equipment which code is correct. Generally, the codes
are displayed in order of age of the equipment. Older
equipment first, younger equipment at the end. Sometimes
you will have to try several codes before you find the right
code for your equipment.
1. Make sure your equipment is switched on (for example
TV).
2. Press and hold the SETUP (8) key until the LED indicator
lights continuously. Release the SETUP key.
3. Press and release the mode key (3) of the device you
want to control (for example TV).
4. Enter the 3 digit code from the Code Book by using the
key pad (9). The LED (2) turns off after the last digit is
entered. If you entered a wrong code the LED blinks for 3
seconds and then goes off. You have to repeat from step 2.
5. Point the remote in the direction of your TV and press the
POWER button (1). Your device should turn off. Check
other functions (for example for a VCR FF or REW, etc.). If
certain functions are not responding, this indicates that the
entered code is not the correct one. In that case repeat the
above procedure with the next corresponding code of your
brand.
6. Repeat this procedure from step 1 for the other equipment
you want to control (VCR, DVD, SAT,...). If your equipment
(TV, SAT, etc....) does not respond, try the other codes for
your brand. If it still doesn't respond, try the manual code
search method (4.4 Manual code search).
4.2. Automatic code search for some well-known brands
If your brand is listed hereafter, you can use the brand
search method (faster than the "manual" and the "automatic
code search").
BRAND CODE
Philips & Sub brands / Radiola 1
Sony / Panasonic / JVC / Sharp
/ Akai / Toshiba / Daewoo 2
& Other Japanese brands
Thomson / Brandt / Ferguson 3
1. Turn on the device you want to control.
2. Press and hold SETUP (8) until the LED indicator (2)
lights steadily. Release SETUP button.
3. Press the mode button (3) that matches the equipment
you wish to control. The LED (2) blinks once.
P/N 033000=XXXXX
BRAND CODE
Telefunken / Saba /
4
Normende
Grundig / Blaupunkt 5
Nokia / Finlux / ITT &
Other Scandinavian 6
brands
9 Rev.01-06-06