Publicité
Les langues disponibles
Les langues disponibles
Quick start guide
1) Put the batteries in
1. Open the cover on the back of the 8 in 1 Universal
Remote Control
2. Insert 2 batteries (AAA alkaline). Make sure the batteries
are NEW.
2) Program your 8 in 1 Universal Remote Control
1. Turn on the equipment that you wish to control (TV, VCR,
CBL, DVD, CD, DVR, SAT, AUX).
2. The AUX key allows you to program and control any
equipment such as TV, VCR, DVD, CD, CBL, ASAT
(Analogue Satellite Receiver) or DSAT (Digital Satellite
Receiver).
3. Take the code book supplied with the 8 in 1 Universal
Remote Control and find the brand of the equipment you
wish to control. E.g. if you have a Thomson TV look for
Thomson under the TV section.
4. Press and hold on the key marked "SETUP" (8) until the
red LED (2) stays permanently on. This takes about 3
seconds. Release the "SETUP key".
5. Press and release the TV, VCR, CBL, DVD, CD, ASAT,
DSAT or AUX mode key (3), in accordance with the
appliance you wish to control.
6. From the code book take the first number corresponding
to your equipment and enter the number by pressing the 0-9
key pad (9). Each time you press a key the red LED (2) will
flash.
7. If the number is correctly entered the red LED will turn off.
If the number is incorrect then the red LED will flash fast. If
incorrect you will need to restart at 4.
Press the POWER key (1) . If your equipment switches off
you have found the right code. If it does not switch off, you
will need to restart from 4.
Sometimes there are several codes that have similar
features. If you find that your 8 in 1 Universal Remote
Control does not work for some functions, you may need to
try another code.
P/N 033000=XXXXX
6
Rev.01-06-06
Publicité
