Master TAKE CONTROL BASIC UR81 Guide Utilisateur page 11

4. Press CHAN+ (5) repeatedly until the channel changes. If
you step past the correct code use CHAN- (5) to go back to
the right code.
5. When the equipment you want to control reacts, press -/--
(11) to confirm the code.
Note: If your equipment doesn't have CHAN+ you can use
PLAY (VCR or DVD) (19) or POWER (1) key. The search
starts after the last registered code. If that was 030, the
search starts at 031 until the last possible code and then
goes from 000 to 029. Note: if certain functions of your
equipment can't be controlled you will have to find a different
code for your brand.
4.5. Identifying codes found
If the batteries are taken out of the remote for a longer
period, the programmed codes can be erased from the
memory. Therefore it is wise to write down the codes, so you
will be able to reprogram the remote control quickly If you
don't know the code (for example because you found the
code by autosearch) you can identify it as described below:
1. Press and hold SETUP (8) until the LED indicator (2)
lights steadily. Release SETUP.
2. Press the mode key (3) for the equipment you want to
identify (VCR, CBL, DVD, CD, ASAT, DSAT or AUX). The
LED blinks once.
3. Press again SETUP. The LED blinks once.
4. To identify the first digit press each number button from 0
- 9 (9) until the LED blinks. The number you pressed is the
first digit of the code.
5. Press each number key from 0 - 9 as above to find the
second digit.
6. Press each number key from 0 - 9 as above to find the
third digit. When the third digit has been found the LED will
go off.
4.6. Default Volume Control for satellite
In factory default, in Satellite mode the volume is controlled
by the TV. However, some Satellite tuners have their own
volume control. You can reprogram the remote so the
volume is controlled by the satellite receiver instead of by
the TV.
1. Press and release the TV Mode button (3) – remote must
be in TV mode for this procedure.
2. Press and hold SETUP (8) button until LED remains on.
3. Release SETUP button.
4. Press and hold the Mute (4) key for approximately 8
seconds. LED will stay off for the 8 second period, then blink
once to indicate volume default acceptance and then remain
off.
5. Remote volume default is now set.
6. If the Take Control Basic Remote was previously
controlling the television volume in SAT mode, it will now
control the volume of the satellite decoder. If it was
previously controlling the volume of the satellite decoder, it
will now control the volume of the television.
P/N 033000=XXXXX 11 Rev.01-06-06