Publicité
Les langues disponibles
Les langues disponibles
4
Installation
Read the "Safety Instructions" section first!
4.1 The right place for installation
Your product requires adequate air circulation to
function efficiently. If the product will be placed in an
alcove, remember to leave at least 5 cm clearance
between the product and the ceiling, rear wall and
the side walls.
If the product will be placed in an alcove, remember
to leave at least 5 cm clearance between the
product and the ceiling, rear wall and the side
walls. Check if the rear wall clearance protection
component is present at its location (if provided with
the product). If the component is not available, or
if it is lost or fallen, position the product so that at
least 5 cm clearance shall be left between the rear
surface of the product and the wall of the room.
The clearance at the rear is important for efficient
operation of the product.
4.2 For Products With Water
Fountain / Ice Maker
used. Do not use the old hose sets. Do not extend
the hoses!
Do not perform installation on the hot water inlet.
The pressure for the cold water inlet shall be 80 PSi
(550 kPa) maximum. If your water pressure exceeds
80Psi or has a water impact effect, use a pressure
limiting valve on your mains system. Ask help from
professional plumbers if you do not know how to
control your water pressure.
High pressure may cause damage to the hose
connections and pose a risk of flooding.
freezing of hoses. The operating water temperature
interval shall be 0.6°C (33°F) minimum and 38°C
(100°F) maximum. There is a risk of flooding if the
hose is cracked/perforated.
A
WARNING:
sockets in power connection.
Do not use extension or multi
WARNING:
B
no responsibility for any damage caused
by the work carried out by unauthorized
persons.
WARNING:
B
must be unplugged during installation.
Failure to do so may result in death or
serious injuries!
WARNING:
A
narrow for the product to pass, remove
the door and turn the product sideways; if
this does not work, contact the authorized
service.
vibration.
heater, stove and similar sources of heat and at
least 5 cm away from electric ovens.
keep in damp environments.
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
distance between the product and the ceiling
and the walls.
4.3 Attaching the plastic wedges
Use the plastic wedges in the provided with
the product to provide sufficient space for air
circulation between the product and the wall.
1. To attach the wedges, remove the screws on
the product and use the screws provided with the
wedges.
10 /25 EN
The manufacturer assumes
The product's power cable
: If the door span is too
Refrigerator / User Guide
Publicité
