Publicité
Les langues disponibles
Les langues disponibles
22
3.11
rear exit
EN
FAILURE TO CREATE A SEAL TO THE FIREBOX WITH THE EXHAUST COLLAR ASSEMBLY WILL CAUSE
THE APPLIANCE TO FUNCTION IMPROPERLY AND CAN CAUSE INJURY OR PROPERTY DAMAGE.
Remove the safety screen and glass front, refer to " SAFETY
A.
SCREEN / DOOR REMOVAL AND INSTALLATION" section.
Remove the contents from the firebox and set aside, you will
B.
need the exhaust flue collar from the top of the log carton.
To ease assembly, remove the four hex head screws securing
C.
the deflector from inside the top front of the firebox, refer to
Figure 1.
Place the gasket (provided) over the 4" (102mm) flue collar assembly and
D.
bend along perforation.
From inside the firebox, insert the 4" (102mm) flue collar through the back
E.
of the firebox. Install the rear exit shield onto the 4" (102mm) flue collar, see
"REAR EXIT SHIELD" section for installation instructions.
Secure the flue collar assembly, gasket and rear exit shield using the four
F.
hex head 3/8" thread cutting screws, refer to Figure 2. NOTE: Do not
overtighten. The gasket needs only to be snug against the firebox.
Reattach the deflector using the four screws and install the log set, glass
G.
door and safety screen.
3.12
rear exit shield (for rear vent only)
Remove the safety barrier assembly and door from the appliance, refer to the "SAFETY SCREEN &
A.
DOOR REMOVAL / INSTALLATION" section of the manual for detailed instructions.
Loosen the two screws, that secure the exhaust plate, and slide the baffle in place by sliding its
B.
slotted openings behind the screwheads, tighten the two previously loosened screws. Refer to the
illustration below.
Reinstall the door and safety barrier assembly on the appliance, refer to the "SAFETY SCREEN &
C.
DOOR REMOVAL / INSTALLATION" section of the manual for detailed instructions.
NOTE: THIS SHIELD IS USED TO BLOCK THE VIEW THROUGH THE VENTING TO THE OUTDOORS.
W415-1541 / C / 11.23.17
WARNING
!
Fig. 1
DEFLECTOR
DÉFLECTEUR
Fig. 2
Publicité
