HQ Power MICW30 Serie Notice D'emploi page 4

Overview
5.
Refer to the illustrations on page 2 of this manual.
Receiver
1 power ON/OFF button
2 power LED
3 antenna A receive LED
4 antenna B receive LED
Microphone
A power ON/MUTE/OFF switch
B battery indicator LED
System setup and use
6.
Refer to the illustrations on page 2 of this manual.
• Mount or place the receiver at least 1 meter above the floor and at least 1 meter clear from walls or large
surfaces.
• Connect the audio output jack [9] to a public address (PA) system (not incl.) using a suitable cable (not incl.)
•
Insert the DC power adaptor jack in the DC power input [8]. Only use the included power adaptor to avoid
damage to the system. Do not plug the adaptor in the mains yet.
•
Plug the power adaptor into a suitable mains outlet and press the power ON/OFF button [1] on the receiver.
The power LED [2] turns red.
•
Insert batteries (not incl.) into the microphone (see §9) and switch it on by moving the power ON/MUTE/OFF
switch [A] to the ON position.
•
When the microphone is switched on, it will communicate with the receiver through antenna A [6], indicated
by LED [3] or antenna B [7], indicated by LED [4]. Which antenna the system uses depends on the signal
strength and environmental conditions.
•
Talk into the microphone head [C]. Control the volume of the signal with the volume knob [5] on the receiver.
•
Mute the microphone with the power MUTE [A]. The antenna receive LEDs [3 & 4] are both off.
•
After use, switch the microphone off by moving the power ON/MUTE/OFF switch [A] to the OFF position.
Switch off the receiver by pushing the power ON/OFF button [1].
Operation tips
7.
•
Increase signal reception by changing the position of the antennas. Best performance will usually be obtained
with a 90° angle between the antennas.
•
Avoid placing the receiver antennas near metal surfaces and obstruction.
•
Make sure that you have the correct batteries for in the microphone. Do not use rechargeable batteries.
•
Turn off the microphone before changing the batteries.
•
Keep the distance between microphone and receiver antenna as short as possible. Avoid large obstacle in the
line-of-sight between microphone and receiver.
•
Perform a walk-through test before performance or presentation. If dead spots are found, adjust location of the
receiver or mark those spot and avoid them during the presentation.
•
Replace the battery as soon as the red light [B] is on.
•
Do not use multiple wireless microphone systems simultaneously on the same frequency!
Maintenance
8.
•
All screws should be tightened and free of corrosion.
•
The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections ...
•
The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
•
Disconnect the device from the mains prior to maintenance activities.
•
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
•
Do not open the receiver. There are no user-serviceable parts.
• Contact your dealer for spare parts if necessary.
• Remove power and batteries when the device is not used for a long time.
10/03/2010
MICW30x
5 volume knob
6 antenna A
7 antenna B
8 DC power input
9 audio output jack
C microphone head
D battery cover
E battery compartment
4
Rev. 02
®
©Velleman nv