Dometic WAECO PerfectCharge IU152A Instructions De Montage Et De Service page 42

_PerfectCharge_IU152A-IU802A.book Seite 42 Dienstag, 15. September 2009 5:19 17
Technical description
6.3 Control elements
Front view (fig. 2, page 3)
No. Description
1 Main switch
0/Off: device is switched off
I/On: device is switched on
Using a remote control (accessory) the unit can be operated in sleep
mode (low noise).
(sleep mode: half power)
II/Sleep Mode: device runs quietly
Contrary settings by the remote control (accessory) will be overwritten.
2 Status LEDs: show the current charging status
(see chapter "Charging characteristics" on page 51)
U Phase: the IU0U automatic charger is in the U phase
IU Phase: the IU0U automatic charger is in the U0 phase
I Phase: the IU0U automatic charger is in the I phase
3 Fan
Rear view (fig. 3, page 4)
No.
Description
1 230 V power supply connection
2 RC: connection for remote control (accessory)
3 TS: connection for temperature sensor (accessory)
4 Battery connection terminals
BATT 1+, BATT 2+, BATT 3+: positive terminal for supply batteries
BATT –: negative terminal
START BATT + (only IU152A), BATT 1+ (only IU154A, IU252A): posi-
tive terminal of the starter battery
42
PerfectCharge