Hansgrohe Metris S 310671 Serie Instructions D'installation page 7

Install the spout. Rotate the spout escutcheon if neces-
sary, so that the hole for the pull rod is at the rear.
Tighten the mounting nut. Tighten the tensioning screws.
Screw the connecting hoses into the spout tee.
Connect the hoses to the valve outlets.
Use two wrenches so that the
hoses do not twist or become
loosened from the spout tee.
Install the supply lines (not included).
Install the drain.
Turn on the water and check all connections for leaks.
English
7